 |
|
Glue Joint Router Bit
|
|
||||||||||||||||||||||||||||
|
2 flute, carbide tipped. Produce a strong glue edge-joint for door panels, table tops, and cabinets. Center the cutter on the stock and cut both tongue and groove in one pass. Flip wood, cut matching side, then assemble. Use with stock up to 1-1/4" thick. FREE Instruction link at right. 1/2" shank. See Katana® Jointmaking Set!
Set-Up Block For Katana® Glue Joint Bit #18846 Save time, effort and wood. The pre-cut joint profile allows quick, proper height adjustments with accurate setup everytime. Set-Up Block will not distort or swell. For 3/4" stock. Instructions included.
|
|||||||||||||||||||||||||||||
Drawer Lock Router Bit
|
|
||||||||||||||||||||||||||||
| 2 flute, carbide tipped. Making strong drawers is easy with our Drawer Lock Bit. Rout the drawer front and sides with the bit mounted in a table. Attach sides to front of drawer with perfectly mated, strong glue joints. Minimum stock thickness is 3/8" for drawer sides and 1/2" for drawer front. FREE Instruction link at right. 1/2" shank. See Katana® Jointmaking Set!
Set-Up Block For Katana® Drawer Lock #18850 Save time, effort and wood. The pre-cut joint profile allows quick, proper height adjustments with accurate setup everytime.
|
|||||||||||||||||||||||||||||
Lock Miter Router Bits
|
|
|||||||||||||||||||||||||
2 flute, carbide tipped. To join materials at 90º by cutting a 45º miter and a perfect matching tongue and groove glue joint. This extremely strong joint not only increases mechanical strength, but also increases glue surface area and automatically aligns parts. Make frames, boxes, right angle and parallel angle joints. Item #17849 joins stock from 7/16" to 11/16". Item #17850 joins stock from 5/8" to 1-1/16" thick. FREE Instruction link at right. 1/2" shank. See Katana® Jointmaking Set!  Lock Miter Instructions (PDF)
 Set-Up blocks for Katana® Lock Mitre bits are featured below.
|
||||||||||||||||||||||||||
| |||||