|
TripleWing Bits Cut Smoother, Last Longer. |
||||||
|
||||||
| See Review from Workbench, August '06 Once again, MLCS is proud to be at the vanguard of routing technology with the introduction of our NEW THREE-wing, carbide tipped router bits. Larger cutters with an extra cutting blade (versus standard 2-flute bits) save time by allowing more aggressive cuts and, hence, less passes. These 1/2" shank bits can be run at reduced speeds, helping to eliminate burning on problem woods, such as, cherry, oak, etc. Our introductory line features common bit types and sizes. MLCS TripleWing bits:
|
![]() |
TripleWing Round Over Bits Ideal for decorative and smooth rounded edges. Lower depth setting will produce a decorative bead. Also used for drop leaf table joints, molding, etc. TripleWing Straight Bits Plane edges, cut grooves, rabbets, slots, and dadoes. Also used for mortising and carving, and when a flat bottom is needed. TripleWing Flush Trim Bits For use in trimming laminates and pattern routing. V-notch bits make a "V" where two pieces join together, hiding a less than perfect joint. TripleWing Chamfer Bit Ideal for beveling, decorative edges, and for producing a 45° mitres. TripleWing Rabbeting Bit Use for cutting rabbets, tongue & groove joints and ship lap joints. |
||||
|
TripleWing Raised Panel Bits |
|||||||||||||||||||||||||||||||||||||
|
|
|||||||||||||||||||||||||||||||||||||
TripleWing Raised Panel Bits
|
|||||||||||||||||||||||||||||||||||||
![]() |
![]() |
||||||||||||||||||||||||||||||||||||
![]() |
|||||||||||||||||||||||||||||||||||||



