
-
Dado Clean Out Router Bits
- Reviews
Dado Clean Out Bits Sale!
2 flute, carbide tipped, with a 3/16" cutting length. Clean out rough dado cuts and finish rough stock. The bearing rides on the shoulder of the dado as the base of the router rides on the surface, cleaning out a rough cut with great accuracy. Dado Clean Out bits are great for pattern cutting, Also used for mounting small hinge templates and routing signs. Patent No. 269,348.
Dado Clean Out Router Bits | ||||
---|---|---|---|---|
Item # | Large Diameter | Shank Size |
![]() |
|
#5381 | 31/64" | 1/4" | $14.95 | ![]() |
#5382 | 1/2" | 1/4" | $14.95 | ![]() |
#5383 | 5/8" | 1/4" | $15.95 | ![]() |
#5384 | 3/4" | 1/4" | $16.95 | ![]() |
#7684 | 3/4" | 1/2" | $18.95 | ![]() |


all customer reviews and ratings
Average Customer Rating: (1 reviews)
Add your own review for this product

By Loring C. Chien (Katy TX US)
I find this great for making half lap joints.
I half lap 2x4 and 1x4 sometimes, I use the table saw to make a series of parallel cuts the width (accurate) and close to the depth of the half lap, very fast. Make the cuts every 1/4 inch or so, does not have to be accurate. Leaves narrow wafers standing vertically. You can go in with a screwdriver and break off the wafers leaving a very rough bottom. Then clean it up with this dado clean out in a router table. Use the bearing to guide against the cuts at the far end and then just freehand over the rest of the width with the bit height in the table setting the exact depth desired.