Router Bits & Woodworking Products

SETS ON SALE! Works with standard 3/4" x 3/8" miter gauges with or without a T-slot. Our track is great for shop built router tables that are not equipped to handle a miter gauge. You can add a miter or sliding fixture to anything that can be routed out to fit the Miter T-Track work bench, table saw extensions, drill press tables, and band saw tables. The miter T-bar slides into the miter track or miter slot in your table saw. The T-bar can be used to make sliding jigs and other fixtures throughout the shop. Add a lock down knob by drilling and tapping the T-bar, there is no end to the possibilities. Use #7785 (1-1/4" Straight bit) to make the groove for the Miter T-Track. T-Track length may vary up to 1/8".

T-Track (A) measures 1-1/4" wide x 1/2" high

Our combo T-Track/Miter T-Track lets you use your miter gauge or tenoning jig, plus T-Track accessories on your router table, band saw table or table saw extension. The T-Track accepts any accessory that uses a 1/4" hex head bolt, such as featherboards, stop blocks or hold downs. The Miter track accepts a standard 3/4" x 3/8" bar or sliding T-Bar. Overall length may vary up to 1/8".

Create custom jigs and fixtures with our Miter T-Track slot locking kit. Lock all types of featherboards onto table saws, router tables and band saws. The T-bar will fit any 3/4" x 3/8" miter T-slot groove. Instructions are included for attaching to a featherboard or making a circle cutter for your router. Includes:

For attaching featherboards, hold-downs or virtually any type of jig to your table saw, router table, or any tool with a standard 3/4" x 3/8" miter gauge slot. Works by applying outward pressure to the "walls" of the miter gauge slot. The "wedge" bolt pushes up into the counter sink hole in the miter bar as it tightens with the star knobs, pushing the end of the miter bar outward for a tight fit. Can be used with stock up to 3/4" thick. Includes:

36 Pieces Total! Easily create your own jigs and fixtures! This handy kit contains: 16 assorted 1/4" x 20 knobs, 16 track bolts plus 4 special T-track nuts. (Was item 9889).

Each of the four aluminum pieces is 1-1/2" long, cut at 90º and pre-drilled and countersunk with 2 holes. Mounting screws are included.